Advertisement
In the event of IR confl icts, please do the following:
1.
Remove the battery cover from the back of the RMT 2-IR remote.
2.
Locate the Dip Switches just above the batteries
3.
Switch the Dip Switches on the RMT 2-IR to any of the combinations pictured
below.
4.
Dip Switches 1 and 2 in the RMT 2-IR correspond with Dip Switches 1 and 2 on
the bottom (underneath a piece of metallic tape) of the 2X1 DVI DL Switcher
respectively. Flip the switches on the outside of the 2x1 DVI DL Switcher to
match the same Remote Channel as the RMT 2-IR. The 2x1 DVI DL Switcher
is now set to a new IR Code.
Remote Channel 1:
Remote Channel 3:
1.
Locate the dip switches underneath the switcher, they will be hidden under-
neath a blank silver sticker, and fl ip dip switch number 4 to the "ON" position.
2.
Plug the IR extender into the Remote port on the front of the Switcher Unit (where
the RMT-2 optional wired remote connects on page 3).
You should now be able to switch using the IR Extender (shown on the bottom of page 6
immediately opposite this sentence).
IR CODE CONFLICTS
1
2
1
2
IR EXTENDER INSTALLATION
How to Connect the IR Extender
(Gefen part #EXT-RMT-EXTIR)
Remote Channel 2:
Remote Channel 4:
7
1
2
1
2
Advertisement
