Overheating During Washing Cycle More Than 88°C - Electrolux washing machine Service Manual

E62
Checks to do:
Get inside the diagnostic
cycle and fill water up to the
glass to make the pressure
switch operate. In the main
board plugs measure
between connector J2-6 and
machine body, you should
find an open circuit . Is the
circuit Open?
- see pic. 20 -
YES
On main board plug
measure between J4-1 and
J4-2 an Ohm value.
(between 5.7 and 6.3 KOhm
at 20 °C)
Do you read the Ohm
value?
- see pic. 16 -
YES
Change the Main board
and run again the diagnostic
cycle to verify any further
possible alarm.
SSD-P APdV, EB, HD 01/05
ALARM CODES
Overheating during washing cycle more than 88° ° ° ° C.
Unplug the connector and
NO
measure between the
washing heating element and
the body of the machine.
Do you measure an Open
circuit ?
Check / change the cables
and repeat diagnostic cycle
to verify any further possible
alarm. You can repeat the
measurement between J2-6
and body of the machine
reconnecting the connector
in the heating element.
Unplug connectors.
Measure directly on the
NO
NTC the Ohm values.
Do you read the right Ohm
– see pic 27
Change/Check the cable
and run again the diagnostic
cycle to verify any further
possible alarm.
NO
-see pic.26-
YES
NO
value?
-
YES
If there are burn marks on
electronic board, see page 13.1-2
8.25
Change the heating
element and run again the
diagnostic cycle to verify
any further possible alarm.
Change the NTC sensor
and run again the
diagnostic cycle to verify
any further possible alarm.
599 34 71-47