Problems During Draining Phase - Electrolux washing machine Service Manual

E21
Checks to do:
Is the drain filter clean?
YES
Is the draining system OK (drain hose
and plumbing where machine is
connected)
YES
Is the drain
pump working?
(in the diagnostic
cycle select step
1 filling and then
step 7 - draining)
(noise from the
pump)
YES
Do the diagnostic
cycle completely
again and verify
any further
possible alarm
code
Is the pump
mechanical
blocked?
YES
Clean and verify that
pump is working
correctly
SSD-P APdV, EB, HD 01/05
ALARM CODES

Problems during draining phase

(Machine tries to drain for 10 min without emptying the tub)
Is the value of the
pump about
200Ω?
(Measure directly
NO
the connector by
the board,
between J2-2 and
J2-7) -see pic.04-
YES
Is there any burn
NO
mark on the board in
drain pump area?
(page 13.1-2)
Change the board
and verify if there is
any burn mark
between pump
connectors due to
possible water
leaking
Clean the filter and run again the
diagnostic cycle to verify any further
NO
Free and check the draining system
NO
Is the value of the
pump about
200Ω?
NO
(Measure directly
on the pump)
-see pic.05-
YES
Check/Replace
the cable and run
again diagnostic
cycle to verify any
further possible
alarm
NO
YES
8.4
possible alarm
Change the
pump and run
again
diagnostic cycle
NO
to verify any
further possible
alarm
Change the board
and repeat the
diagnostic cycle
completely again and
verify any further
possible alarm
599 34 71-47