Electrolux washing machine Service Manual page 36

E43
(2nd page)
Checks to do:
4 Connections
Instant door lock device
- see pic.19
YES
To verify the cable measure the
following connections on main
board plugs:
- Measure between wire on J2-3
and J7, you should NOT find an
open circuit
- Measure between wire on J2-3
and W1, you should NOT find an
open circuit
- Measure between wire on J2-3
and J2-1, you should find an
OPEN circuit
- Measure between wire on J2-1
and the wire going to connector 5
on door lock, you should find a
short circuit
Is the system OK?
- see pic. 13,16,24
YES
Change the Main electronic board
and run again the diagnostic cycle
to verify any further possible
alarm.
SSD-P APdV, EB, HD 01/05
ALARM CODES
There is an incongruity on the component (Triac)
that commands the door lock device.
-
NO
-
Unplug the connectors on
door lock and measure as
follow:
- Measure between
connector 3 and 4, you
should NOT find an open
circuit.
- Between connector 4 and
2, you should NOT find an
open circuit.
- Between connector 4 and
5 you should find an OPEN
circuit.
(numbers are printed on the
component )
Is door lock OK?
YES
Check/change the cables
and run again diagnostic
cycle to verify any further
possible alarm
If there are burn marks on
electronic board, see page 13.1-2
8.18
Change the door
lock and run the
NO
diagnostic cycle
to measure any
further possible
alarm
599 34 71-47