There Is An Incongruity On The Component (Triac) That Commands The Door Lock Device - Electrolux washing machine Service Manual

E43
(1st page)
Checks to do:
3 Connections –Traditional
or instant door lock device.
- see pic 17,18
YES
To verify the cable measure the
following connections on main
board plugs:
- Measure between wire on J2-3
and J7, you should NOT find an
open circuit
-Measure between wire on J2-1
and J2-3, you should find an
OPEN circuit.
-Measure between wire J2-1 and
wire going to connector 4 in the
door lock, you should find a short
circuit.
Is the system OK?
-see pic.13,16,24-
YES
Change the Electronic board and
run again the diagnostic cycle to
verify any further possible alarm.
SSD-P APdV, EB, HD 01/05
ALARM CODES
There is an incongruity on the component (Triac)
that commands the door lock device.
-
NO
Is the door
lock with 3 or
4 connectors?
Unplug the connectors on
door lock and measure as
follow:
- Measure between
connector 3 and 5, you
should NOT find an open
circuit.
- Instead between connector
4 and 5, you should find an
OPEN circuit (numbers are
printed on the component).
Is the door lock OK?
YES
Check/change the cables
and run again diagnostic
cycle to verify any further
possible alarm
If there are burn marks on
electronic board, see page 13.1-2
8.17
4 Connections
(Instant door lock
device)
- see next page (8.18)
Change the door
lock and run the
NO diagnostic cycle
to measure any
further possible
alarm
599 34 71-47
-