Cyclo Vac GS71 Owner's Manual page 11

CHANGING THE BAG
Change the bag when the one in place is full.
Frequency will depend on the use of the unit.
1. Disconnect the unit from power source.
2. Remove the flexible hose from unit lid adaptor
(figure 5).
3. Unlatch the two clips and remove lid (figure 6).
4. Rotate the bag until the notches are lined up
with the tabs on the bag adaptor, and remove
bag.
5. Seal bag opening with adhesive provided (see
instructions on bag collar).Discard used bag.
6. Install the new bag, ensuring the notches are
aligned with the tabs on the adaptor (figure 7).
Then rotate so they are slightly misaligned, and
thus ensure bag retention.
7. Ensure adequate sealing by ensuring that
the bag membrane is inserted as far as the
retention ring.
8. Replace unit lid and seal by latching both clips.
9. Replace the flexible hose to unit lid adaptor.
10. Reconnect unit to power source.
Use only genuine replacement bags.
Failure to do so could void the
warranty on your vacuum unit.
MAINTENANCE
retention ring
Maintenance
Type 3 bag
Part Number: TDSAC70C
figure 5
figure 6
figure 7
11