HearthStone Craftsbury 8390 Owner's Manual page 14

▌ WARNING:
DO NOT CONNECT THE STOVE TO A
CHIMNEY FLUE SERVING ANOTHER
APPLIANCE.
Make sure the size of the chimney's flue is
appropriate for the Craftsbury. The Craftsbury
requires a 6" (152 mm) inside diameter flue for
new installations. A 6" diameter flue provides
adequate draft and performance. You can use
an 8" (203 mm) diameter existing interior flue
with a reducer. An oversized flue, especially a
cold, exterior flue, contributes to draft reduction
and creosote accumulation. (In this case, bigger
is NOT better.)
When purchasing a prefabricated chimney to
install with your stove, be sure to also purchase
from the same manufacturer all of the necessary
components such as the wall pass-through (or
ceiling support package), "T" section package,
fire-stops (when needed), insulation shield, roof
flashing, chimney cap, and any other needed
accessories. Follow
instructions when installing the chimney and
accessories. In addition, be sure to maintain all
manufacturers' recommendations for the proper
clearances to the chimney.
Reversing the flue collar
The Craftsbury can be vented either horizontally
or vertically by reversing the flue collar.
HearthStone Quality Home Heating Products Inc ®
the manufacturer's
Mantle Clearances for ZC or
Masonry Fireplace.
SIDE CLEARANCE:
(from top corner)
8" - TO 2" OR LESS SIDE TRIM
9" - TO 2"-4" SIDE TRIM
TOP CLEARANCE:
(from top)
14"- TO 0"-6"
16"- TO 6"-8"
18"- TO 8"-10" MANTLE LENGTH
14
MANTLE LENGTH
MANTLE LENGTH
Model 8390