Power On; Normal Power Off; Emergency Power Off - Kodak DryView 6800 User Manual

Using and Maintaining the Imager

Power ON

Normal Power OFF

Emergency Power OFF

2-2
After the initial startup of the Imager, the power button on
IMPORTANT:
the local panel should be used to power ON and power OFF
the Imager.
If this is the first time the Imager has been powered ON, set the power switch
to the "|" (ON) position and press the power button on the local panel. The
Imager performs a power-up self test that takes about 5 minutes. After the self
test, there are some initial boot-up screens before the local panel Main
Screen appears.
After the power-up test, the Imager begins a warm-up period that can last up
to 35 minutes. The warm-up period varies depending on how long the Imager
has been turned OFF, the ambient temperature, and whether the Imager is in
power save mode. During warm-up, the Imager can receive and store images,
but cannot print films. When the Imager reaches operating temperature, it
starts printing any images accumulated during the warm-up period.
During warm-up, you can use the touch screen to check the contents of the
film drawers and to open the film drawers to load new film cartridges if
necessary.
The local panel should be used to turn off power to the
IMPORTANT:
imager, except in an emergency. Using the main power
switch could cause the imager to shutdown incorrectly and
possibly cause some corruption of the operating system.
Turn the Imager OFF if you do not expect to use it for an extended period of
time.
On the local panel, press the power button.
1.
On the touch screen, touch:
2.
• Power OFF
• OK
All films in process will be completed before the Imager does a controlled
shutdown (similar to a computer shutdown).
If an emergency arises that requires the immediate shutdown of the Imager,
press the power switch located at the lower right front of the Imager. The
Imager will be shut down. Films in process will not be completed and will
remain where they are until removed (see
Imager Powered OFF" on page
To restart the Imager turn ON the power switch. After warming up, the Imager
automatically reprints any films that were in process when power was
interrupted.
8F2927
"Correcting Film Jams With the
3-2).
January 17, 2007