Advertisement
- Connecting point for the reverse signal (example) -
Tip
• Be sure to connect the reverse signal cable. If it is not
connected, the vehicle position may be incorrect when
the vehicle is reversed.
• Use a circuit tester to confirm that a sensing voltage of
6 V or higher is generated when the vehicle is reversed.
1
Use a splicing connector to connect the reverse signal
cable (green) coming from the main unit to the reverse
signal cable of the vehicle.
2
Route the reverse signal cable to the main unit .
- Using the splicing connector -
1
Insert the connection cable [vehicle speed pulse signal
cable (purple/white), parking brake cable (red/white),
or reverse cable (green)] from the main unit and the
vehicle cable into the splicing connector.
2
Press down the cover of the splicing connector and
squeeze it until it locks.
Attach a splicing
connector at this location
Reverse signal cable
Vehicle speed pulse signal cable
(purple/white), parking brake cable
(red/white), or reverse cable (green)
Harness in the car
7
- 9 -
Reverse lamp
Reverse signal cable
Lock
7
Advertisement
