5 • Installing the Canopy and Canopy Trim Ring
Step 5-2
Canopy
Steps 5-4 – 5-5
Hunter Fan Company
5-1. Holding the canopy, raise the fan off the hook.
Ceiling Plate
5-2. Align the slots in the canopy with the tabs on the ceiling plate.
5-3. Raise the canopy over the ceiling plate. Rotate the canopy
clockwise until the tabs on the ceiling plate totally engage with
the slots in the canopy.
5-4. Partially install the three canopy screws into the canopy one at a
Canopy Trim
Ring
time. Once all three screws are in, tighten them.
5-5. Using both hands, push the canopy trim ring up to the top of the
canopy. The canopy trim ring will snap and lock into place.
Step 5-3
Canopy
Should you need to remove the canopy
trim ring, follow these steps:
1. Locate the tab indicators, small
bumps on top of tabs.
2. Press firmly on opposite sides of the
ring towards the canopy. The tabs
will flex out releasing the trim ring
from the canopy.
Screw
42735-01 • 11/12/06