Assembling And Hanging The Fan - Hunter 42735-01 Installation And Operation Manual

3 • Assembling and Hanging the Fan
Steps 3-2 – 3-3
Steps 3-5 – 3-6

Low Profile Screw
Hunter Fan Company
installation instructions.
Downrod
3-1. Unbundle the wires from the fan.
For Standard or Angle mounting:
3-2. To assemble fan to hang down from a flat or angled ceiling, insert
Canopy
Canopy
3-3. Loosen the square head set screw on the adapter to install the
Trim Ring
Set Screw
Low Profile Washer
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the low
profile washer.
3-4. Remove the set screw from the adapter.
3-5. Place the low profile washer (lip up) into the canopy. Be sure the
3-6. Align the holes in the washer with the holes in the adapter.
3-7. Raise the fan and place the hook on the ceiling plate through the
WARNING: Fan may fall if not assembled as directed in these
the downrod through the canopy and canopy trim ring. Feed the
wires from the fan through the downrod.
pipe and ball assembly. Note: When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
normal. Securely retighten the set screw with a wrench or pliers.
Skip to Step 3-7.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
green ground wire is pointing up toward the ceiling.
Assemble securely with three low profile screws.
U-shaped hole in the rim.
Step 3-7
U-shaped
Hole
42735-01 • 11/12/06