Installing The Canopy And Canopy Trim Ring - Hunter ceiling fan Installation And Operation Manual

5 • Installing the Canopy and Canopy Trim Ring
Step 5-1 Step 5-1
Tab
Groove
Step 5-2
8
Step 5-3
Canopy
Canopy
Trim
Ring
Hunter Fan Company
WARNING: Failure to complete the following steps could cause the fan
to fall.
Note: It is recommended you use a magnetic tip screwdriver for the
following steps.
5-1. Rotate the hanger ball so the tab in the canopy is secure in the
hanger ball groove. Note: Your fan may have multiple tabs and
grooves that must be aligned.
5-2. Swing the fan up to align the canopy screw holes with the
mounting holes on the ceiling plate.
WARNING:  e slots in the canopy must remain engaged while
swinging the canopy for alignment.
5-3. Holding the canopy up with the screw holes aligned, partially
install two canopy screws into the holes opposite the ceiling plate
tabs.
5-4. Partially install a canopy screw between the slots in the canopy.
When all the holes are properly aligned, securely tighten all three
canopy screws.
5-5. Verify that the tabs in the canopy are still in the grooves of the
hanger ball.
5-6. Align the tabs on the trim ring opposite the grooves in the hanger
ball. Using both hands, push the canopy trim ring up to the top of
the canopy.  e canopy trim ring will snap and lock into place.
Note: Should you need to remove the trim ring, press fi rmly on
opposite sides of the trim ring directly above the groove in the
hanger ball.  e tabs will fl ex out releasing the canopy trim ring.
Canopy Screw
42607-01 • 02/16/06