Assembling And Hanging The Fan - Hunter Type 2 Models Owner's Manual And Installation Manual

Standard or Angle Mounting
Steps 3-2 – 3-3
Set Screw
Low Profile Mounting
Steps 3-5 – 3-6
Green
Ground
Wire
Canopy
Trim Ring
Locking Screw
Step 3-6 (Detail)
3 • Assembling and Hanging the Fan
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3-1. Unbundle the wires from the fan.
Downrod For Standard or Angle mounting:
3-2. Insert the downrod through the canopy and canopy trim ring.
Feed the wires from the fan through the downrod on one side of
Canopy
the pin in the ball.
3-3. Loosen the square head set screw on the adapter to install the
Canopy
pipe and ball assembly. Note: When the pipe and ball assembly
Trim Ring
is fully installed, 2-3 threads on the pipe will still be visible; this is
normal. Securely retighten the set screw with a wrench or pliers.
Skip to Step 3-7.
Locking Screws
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
Low Profile
Washer
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the low
profile washer.
3-4. Remove the set screw from the adapter.
Canopy
3-5. Place the low profile washer into the canopy with the lip down.
3-6. Align the holes in the washer with the holes in the adapter.
Assemble securely with three locking screws.
Hanging the fan:
3-7. Raise the fan and align the slots in the canopy with the hooks on
the ceiling plate.
Note: To hang the fan, you must tilt the canopy to an almost
Adapter
vertical position so that the canopy slots sit on the ceiling plate
Locking Screws
hooks.
Low Profile
Washer
42619-01 • 04/24/12 • Hunter Fan Company
CAUTION: The adapter has a special coating on the threads. Do
6