Assembling And Hanging The Fan - Hunter Type 2A Series Owner's Manual And Installation Manual

Square
Hanger
Motor
Assembly
#8-32 x 1" Screw
3 • Assembling and Hanging the Fan
3-1. Position the square hanger so that the green ground wire attached
to the square faces out of the large opening in the metal bracket.
3-2. Holding the wires out of the way, lift the motor assembly and
place the square hanger into the opening in the ceiling plate.
WARNING: Make sure the square hanger can not rotate in the
metal bracket. Failure to do so could result in the fan falling.
3-3. Install two locking screws through the holes in the side of the
metal bracket to secure the square hanger.
Green
Ground Wire
Step 3-1
Green
Ground Wire
Step 3-2
Locking Screw
Step 3-3
8
42885-01 • 03/30/10 • Hunter Fan Company