L.B. White Pilot Light Ignition Installation And Service Manual page 25

Model A A B200 a a nd A A B250
5. Secure the cord in place at the entry hole on the case
front with the strain relief provided in the thermostat kit.
6. Loosen the terminal strip screws that hold the jumper in
place. Remove the jumper.
August 1999
7. Push the exposed conductors of the power supply and
power return leads beneath the terminal strip screw
plates previously occupied by the jumper. Tighten the
screw plates and tug on the leads to make sure the
leads are securely attached.
8. Attach the ground lead terminal to the ground screw in
the enclosure.
9. Reconnect the heater to its electrical supply and open
the fuel supply valves to the heater.
10. Light the pilot. Set the thermostat so the fan motor
starts and the burner lights. Check the heater for proper
operation.
11. Set the thermostat to the desired temperature.
Reinstall the electrical enclosure cover.
Installation
Instructions
Remote Thermostat
2.9-4 4