Port Statistics - Planet SGSW-24040 User Manual

• Local Port
• Chassis ID
• Remote Port ID
• System Name
• Port Description
• System Capabilities
• Management Address
Buttons
: Click to refresh the page immediately.
Auto-refresh : Check this box to enable an automatic refresh of the page at regular intervals.

4.14.6 Port Statistics

This page provides an overview of all LLDP traffic. Two types of counters are shown. Global counters are counters that refer to
the whole stack, switch, while local counters refers to counters for the currently selected switch. The LLDP Statistics screen in
Figure 4-14-5 appears.
The port on which the LLDP frame was received.
The Chassis ID is the identification of the neighbor's LLDP frames.
The Remote Port ID is the identification of the neighbor port.
System Name is the name advertised by the neighbor unit.
Port Description is the port description advertised by the neighbor unit.
System Capabilities describes the neighbor unit's capabilities. The possible
capabilities are:
1. Other
2. Repeater
3. Bridge
4. WLAN Access Point
5. Router
6. Telephone
7. DOCSIS cable device
8. Station only
9. Reserved
When a capability is enabled, the capability is followed by (+). If the capability is
disabled, the capability is followed by (-).
Management Address is the neighbor unit's address that is used for higher layer
entities to assist the discovery by the network management. This could for
instance hold the neighbor's IP address.
301
User's Manual of SGSW-24040 / 24240 Series