Using The Mail Notification Function To Report Problems; Reading Problem Mail Notification Function - Epson EB-Z8455WU User Manual

Using the Mail Notification Function to Report Problems

By setting the Mail Notification function from the projector's
Configuration Menu, notification messages will be sent to the preset email
addresses when a problem or warning occurs with a projector. This will
enable the operator to be notified of problems with projectors even at
locations away from the projectors.
Settings - Mail Notification p.73
• Up to three notification destinations (Addresses) can be recorded,
q
and notification messages can be sent to all three destinations at
once.
• If a projector develops a critical problem and suddenly stops
working, it may not be able to send a message notifying an operator
of the problem.
• Monitoring is possible if Standby Mode is set to Communication
On from the Extended menu of the projector's Configuration Menu,
even if the projector is in standby state (when the power is off).
p.57
s

Reading Problem Mail Notification Function

When the Mail Notification function is set to On and a problem/warning
occurs in the projector, the following e-mail is sent.
Sender: Email Address 1
Subject: EPSON Projector
Line 1: The name of the projector where the problem has occurred
Line 2: The IP address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The following table shows
the details that are given in the message for each item. To deal with
problems/warnings, see "Reading the Indicators"
Message
Clean Air Filter
Network Menu - Administrator
s
p.83
s
Cause (Problems/Warnings)
Air Filter Notice
Message
Fan related error
High-speed cooling in progress
Internal error
Internal temperature error
Lamp cover is open.
Lamp out
Lamp replacement notification
Lamp timer failure
Low Air Flow
Low Air Flow Error
No-signal
Power Err. (Ballast)
Sensor error
A (+) or (-) appears at the start of the message.
(+): A projector problem has occurred
(-): A projector problem has been dealt with
Cause (Problems/Warnings)
Fan Error
High Temp Warning
Internal Error
High Temp Error
(Overheating)
Lamp Cover Open
Lamp Error
Replace Lamp
Lamp Failure
Low Air Flow
Filter Airflow Error
No Signal
No Signal is input to the projector. Check
the connection status or check that the
power for the signal source is turned on.
Power Err. (Ballast)
Sensor Error
113