Using The Mail Notification Function To Report Problems; Reading Error Notification Mail - Epson EH-LS9600e User Manual

Useful Functions
Button
c
d
e
f

Using the Mail Notification Function to Report Problems

When you set Mail Notification in the Configuration menu, notification messages are sent to the preset email
addresses when a problem or warning occurs with a projector. This will enable the operator to be notified of
problems with projectors even at locations away from the projectors.
Notification p.96
c
•
Up to a maximum of three notification destinations (addresses) can be registered, and notification
messages can be sent to all three destinations at once.
•
If a projector develops a critical problem and suddenly stops working, it may not be able to send a
message notifying an operator of the problem.
•
If you set Standby Mode to Communication On, you can monitor the projector even if it is in standby
mode (when the power is off).

Reading error notification mail

When the Mail Notification function is set to On and a problem or warning occurs in the projector, the
following email will be sent.
Subject: EPSON Projector
Line 1: The projector name where the problem has occurred
Line 2: The IP address set for the projector where the problem has occurred
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The main message contents are listed below.
Message
No-signal
Changes to the image from each input port.
(The WiHD button is only available for EH-LS9600W.)
Temporarily hides or shows the image.
Changes between 2D and 3D images.
Loads the lens position.
Settings - Standby Mode
s
Contents
No signal
84
Function
s
p.36
s
p.39
s
p.63
s
Network - Mail - Mail
s
p.91
No signal is input to the projector. Check
the connection status or check that the
power for the signal source is turned on.
p.34
Remedy