Other Problems - Epson EB-Z8455WU User Manual

Problem Solving

Other problems

The Remote Control does not work
Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector when it is operated?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining onto
the Remote Receiver?
Is the correct setting for the remote receiver selected?
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. s
Are the remote control ID and the projector ID matched?
Does Remote Control Type match the remote control that you are
using?
Is the optional remote control cable connected to the remote control
or to the projector's Remote port?
Is the remote control button lock set?
Nothing appears on the external monitor
Check
Are images input from a port other than the Computer or
BNC input port?
Are you projecting a split screen?
Point the remote control towards the Remote Receiver. s
The operating range for the remote control is about 15 m. s
Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the remote receiver to
Off from Remote Receiver in the configuration menu. s Settings Menu - Remote Receiver
Check the Remote Receiver from the configuration menu. s Settings Menu - Remote Receiver
Make sure the ID for the projector you want to operate and the ID for the remote control match. To operate all projectors
by remote control regardless of the ID setting, set the ID switch on the side of the remote control to Off. s
Check the Remote Control Type on the configuration menu. s Extended Menu - Operation - Remote Control Type
p.57
When the remote control cable is connected, the remote control light-emitting area or the projector's remote receiver are
disabled. When not using the remote control cable set, disconnect it from the remote control and the Remote port.
When the remote control button lock is set, buttons except for those needed for basic remote control operations are
deactivated. Hold down the [Help] button to cancel the remote control button lock. s
Only RGB signals from the Computer input port or the BNC input port can be displayed on an external
monitor.
Only RGB signals projected on the left screen from the Computer input port or the BNC input port can be
displayed on an external monitor. s
Remedy
p.18
p.18
Remedy
p.29
94
p.55
p.55
p.16
p.150
p.42