Ce25 - Smooth Fitness CE-2.5 Elliptical User Manual

MAINTENANCE and TROUBLESHOOTING
MAINTENANCE
The equipment requires very little maintenance. However; it si recommended to check all screws, bolts and nuts regularly.

After exercising, clean the equipment with a soft absorbent cloth. Do not use solvents. Sweat may cause corrosion: we
recommend that the unit is wiped clean with an absorbent cloth after each workout. A damp cloth with a mild detergent may also
be used on a weekly basis.

Never remove the equipment's protective covers.

Inspect and tighten all parts on the equipment regularly. Replace any worn parts immediately and /or keep the equipment out of
use until repaired.

If the equipment is not used for an extended period of time, the drive belt may become temporarily distorted. This can lead to
sensation of slightly uneven pedaling. However, after a few workouts the effect will disappear as the belt returns to its original
form.
TROUBLESHOOTING
Your equipment is designed to be reliable. However, if you do experience problems with your equipment, please refer to the
troubleshooting guide listed below.
PROBLEM: the console does not light up
SOLUTION: verify the following:

The outlet the machine is plugged into is functional. Double check that the breaker has not tripped.

The correct power cord is being used. Only use the power cord provided with the equipment.

The power cord is not pinched or damaged and is properly plugged into the outlet AND the machine.

The power switch is turned to the ON position.

Turn off the machine and unplug power cord. Remove the console and check that all connections to the computer are secure
and are not damaged or pinched.
NOTE: if your console uses batteries, they may need to be replaced.
PROBLEM: the console lights up but the Time does not count
SOLUTION: verify the following:

Turn off machine and unplug power cord. Remove the console and check that all connections to the console are secure and are
not damaged or pinched.

If doing the above does not fix the problem, the speed sensor and/or magnet may have become dislodged or damaged. Contact
your local Smooth Fitness service technician
PROBLEM: the resistance levels seem to be incorrect, seeming too hard too easy.
SOLUTION: verify the following:

The correct power cord is being used. Only use the power cord provided.

Reset the console and allow the resistance to reset to the default position. Restart and retry the
resistance levels.
PROBLEM: The equipment makes a squeaking or chirping noise
SOLUTION: verify the following:

Equipment is on a level surface.
Loosen all bolts attached during the assembly process. Then grease the threads, and tighten again
www.smoothfitness.com
29