Tamron 300QV-P-CM Instruction Manual page 40

Setting up Image
Output I/O1
setting
I/O
email
Audio OUT
Note:
I/O1, I/O, MD, Audio OUT can be selected at the same time as output.
40
To output a signal when an event has occurred, turn
ON the check box and set the make/break status for an
operation of output signal 1.
Note:
• The make/break status outputs the following signal
operation.
make
break
• If I/O1 is specified as output, I/O1 cannot be used for
a trigger.
To output a signal when an event has occurred, turn
ON the check box and set the make/break status for an
operation of output signal .
Note:
• The make/break status outputs the following signal
operation.
make
break
• If I/O is specified as a trigger, I/O cannot be used
for output.
To send a mail when an event has occurred, turn ON the
check box and set the mail address of the destination.
Note:
Make mail settings in the mail setting part in the [Net-
work] settings screen.
To output an alarm sound from the camera lineout (audio
output jack) when an event has occurred, turn ON the
check box.
Active LOW
Active HIGH
Active LOW
Active HIGH