Basic Operation - Tamron 300QV-P-CM Instruction Manual

Viewing Image

2 Basic operation

Specify the audio I/O and compensated image.
Item
Camera ID
Audio IN
Audio OUT MIC
Beep
Compensation
Select analog image
8
You can set a camera ID with characters up to 19 bytes.
* Input the characters in character codes. The camera ID
is by default set to [TAMRON].
Switch the ON/OFF status of camera microphone output
for the audio device.
Switch the ON/OFF status of microphone output on the
PC side for the camera lineout (audio output jack).
A beep will be output while the button is pressed if the
microphone is ON.
* The beep has been registered in advance.
Select PTZ/horizontal angle of view at 10 degrees
(fixed) or horizontal angle of view at 180 degrees (fixed)
for distortion correction.
Note:
• When the horizontal angle of view is fixed at 10
degrees or fixed at 180 degrees, PTZ cannot be
operated.
• When the setting is changed from [10] or [180] to
[PTZ], the distortion compensation of the central part
will be displayed.
Select a compensated image, the original image, or OFF
for analog output.
Note:
• The compensated image reflects the preset sequence
and split display.
• Use the PN selector on the side of the camera for
NTSC/PAL conversion.
• If you do not want to use the analog output, it is recom-
mended to select OFF in order to reduce the load on
the camera.
The analog output function is a simple function. Use
it for the purpose of adjusting the angle of view at the
time of installation.
Details