Tamron 300QV-P-CM Instruction Manual page 33

2. Specify a suitable value for each item.
Item
Brightness
Contrast
Sharpness
Hue
Saturation
EV
AGC
Max Exposure
Time
AWB
DNR
Flickerless
Light Frequency
BLC Area
Set the brightness (0 to 10).
Set the contrast (-5 to +5).
Set the sharpness (-5 to +5) of the image.
Set the hue (-8 to +8).
Set the color saturation (-5 to +5).
Set the exposure value (-5 to +5).
Set OFF/4dB/30dB as the maximum gain.
Set the maximum exposure time. Select the maximum exposure
time from 1/60, 1/30, 1/15, /15 to 8/15 (sec).
Note:
The sensitivity increases when a longer maximum exposure time is
set, and this is likely to result in blurred images of moving subjects.
The sensitivity decreases when a shorter maximum exposure time
is set, and this can prevent blurred images of moving subjects.
Set the AWB/One-Push status of the automatic white balance.
If One-Push is set, the automatic white balance is executed by
clicking [set] and the value is maintained until the next execution.
Set the OFF/D/D+3D status of noise reduction.
Note:
D: D noise reduction
3D: 3D noise reduction
Set the ON/OFF status of the flicker operation.
Set the frequency of the circumstance from AUTO/50Hz/60Hz
(Flicker-less mode).
Note:
The AUTO mode enables the automatic detection of the fre-
quency in use.
Splits the entire screen of the original image into 16 areas as
shown below, and sets the ON (red)/OFF (gray) status of the AE
wave detection area.
0 1 
4 5 6
8 9 10
1 13 14
Details
3
7
11
15
Setting up Image
33