Tamron 300QV-P-CM Instruction Manual page 29

IR
ND filter
PTZ
Display Window
Setting the function of Trigger/ON/OFF/AUTO1/AUTO.
Trg: Can fix the function of IR cut filter depending on
the Trigger given from outside.
ON: Will keep the color image with IR cut filter in posi-
tion.
OFF: Will keep the B/W image without IR cut filter in
position.
Note:
AUTO1: Color image will have priority.
Will keep color image as long as possible.
AUTO: B/W image will have priority.
Will keep B/W image as long as possible.
Switch the ON/OFF status of the neutral density filter.
To move the cutout position of the compensated image,
click the arrow(s) of the 8-direction key.
Click Zoom IN/Zoom Out button to change the angle of
view of compensated image.
Note:
• If you click the mouse on a position in the original
image, the compensated image will move to an area
close to the position. The clicked position, however,
may not become the center of the corrected image
because distortion corrections have been made (click-
on center function).
• [Speed] allows zoom speed change.
• If the compensated image is clicked and active, you
can change the angle of the compensated image with
the wheel of the mouse.
Rotating forward
Rotating backward
• If you specify an area of the original image with the
mouse cursor, the specified area is shown on the
compensated image.
Specify whether to display the frame in the original
image.
Note:
Turn on [Display Window] to check a rough image area
of target to be compensated.
Viewing Image
Zoom in
Zoom out
9