Tamron 300QV-P-CM Instruction Manual page 37

2. Specify a suitable value for each item.
Item
camera position
rotation
split
auto return
Home position Select the home image from the following ones.
Return time
Privacy Mask
Display Window
Set the camera mounting position to Wall/Ceiling/desk top.
Set whether to enable the horizontal flipping and vertical
flipping of image.
Note:
The frame position of the distortion compensation display is
not reflected if the image is flipped. Therefore, readjust the
position of distortion compensation.
Select the desired compensation image mode from four
modes (No split, split, 3split, and 4split).
Note:
• When you click a split compensated image, an area frame of
the corresponding original image becomes white. Then use
the PTZ key, and adjust and set the angle of view to be shot.
• This function is effective only when PTZ is selected under
[Basic setting]-[Distortion compensation].
Set the ON/OFF status of automatic return to the home image.
Note:
Automatic return to the home image is given priority over
preset sequence.
• PTZ mode
• 10° mode
• 180° mode
Specify 30 seconds or 1 to 10 minutes as time to return to
the home image.
Set the ON/OFF status of use of privacy mask.
Note:
• If ON is set, specify a masking area on an original image
and click [set].
* If you specify an area with the mouse cursor, the frame is
not displayed. The mouse is displayed after clicking the
[set].
• Click [Color setting] to select a mask color. The selected
color is shown in [Color setting].
Specify whether to display the frame in the original image.
Note:
Turn on [Display Window] to check a rough image area of
target to be compensated.
Setting up Image
Details
37