Configuring Advanced Hdd Settings; Setting Up Hdd Redundancy - urmet domus 1093 User Manual

Click the Property button. This will take you to the Property Settings menu, shown in Figure 9.
4.
Figure 9. HDD Property Settings Menu
5. Set HDD to Read-Only.
6. Click the OK button. The HDD is now read-only.
Note:
When a HDD is set to read-only, no more recordings can be written to the disk. In order to enable recordings on
that particular disk again, you must set the HDD to R/W (Read/ Write) in the HDD Property Settings menu. If multiple
HDDs are used, the DVR will automatically record to the next HDD that is not set to read-only.
6.5

CONFIGURING ADVANCED HDD SETTINGS

6.5.1

SETTING UP HDD REDUNDANCY

To insure unexpected failures of hard disk drives, it's recommended to set up HDD redundancy. It is important to note
that in order to set up HDD redundancy, you'll need more than one HDD in your DVR.
To set up HDD redundancy:
Navigate to the HDD Management menu by clicking Menu > HDD management.
1.
Click on the General tab.
2.
Select the HDD to be used for redundancy, as shown in Figure 10.
3.
Figure 10. HDD Management Menu
Click the Property button. This will take you to the Property Settings menu.
4.
Set HDD Status to Redundancy, shown in Figure 11.
5.
Verify at least one other HDD is set to R/W (read/write).
6.
DS1093-059 29