Easy Operations; Power Supply; Insert The Sd-Card And The Sim-Card - Suntek HC-300 User Manual

3.1 Power Supply

To supply power for the camera, four or eight AA size
batteries are needed.
Open the bottom cover. Confirm that the power
switch is at the OFF (Right) position, pull out the battery
depot. Load the fully charged batteries into the depot
according the polarities sign shown below. Push back the
battery compartment to the battery chamber.
The following batteries with 1.5V output can be used:
1. High-density and high-performance alkaline
batteries (Recommended)
2. Rechargeable alkaline batteries
3. Rechargeable NiMH batteries
There are four battery slots. Slot 1 and 2 form one
group ("1" will mark on depot), while slot 3 and 4 form
the other group ("2" will mark on depot) where each
group can supply the power individually.
W h e n i n l o w- b a t t e r y s t a t e , c a m e ra w i l l b e
automatically shut down. Please change the batteries in
time. If you have set the MMS function, it will send you a
SMS or Email to indicate the low battery situation.

3.2 Insert the SD-card and the SIM-card

Open the bottom cover. Insert SD-card into the card
slot with unmarked side upwards.
Please note that the SD-card can only be plugged in
one direction. Make sure that the write-protect switch
of the SD-card is on the "write" position otherwise the
camera cannot be switch on. When use MMS/SMS/
E-mail function, be sure to insert SIM-card into the SIM-
3 Easy Operation
7