Table of Contents
Advertisement
The working voltage of the camera is 6V. The camera
is supplied by four or eight AA batteries.
Please install batteries according to shown polarity.
Please unlock the write-protect before inserting the
SD-card.
Please insert the SD-card when the power switch is at
OFF position before testing the camera.
Please do not insert or take out the SD-card when the
power switch is at ON position.
It is recommended to format the SD-card by the
camera when used at the first time.
The camera will be in USB mode when connected
to a USB port of a computer. In this case, the SD-card
functions as a removable disk.
Please ensure sufficient power when having firmware
upgrade, otherwise the upgrade process could be
interrupted incorrectly. If any fault occurs after improper
upgrading process, the camera may stop function
properly.
As communications networks may vary reasons we
can't guarantee 100% success by sending and receiving
MMS.
2 Cautions
6
Hide quick links:
Advertisement
Table of Contents
