7L. Changing User Codes; 7M. Assigning Authority Level - GE NetworX Series Installation And Setup Manual

7l. Changing User Codes

For systems with areas - someone changing the code of another person must have access to all or
more areas than the user being changed.
Action
[master code]
[user code]
[new user code]
#
while display is prompting
for a user number.

7m. Assigning Authority Level

You must have authority to the area you wish to add or remove from another person's authority.
Action
[master code]
[user code]
If NO...
Master code?
Sched arm only?
Arm only?
Reserved
16
Prompts 'Please Enter Your Code'.
Prompts for a user number.
Prompts for a new code.
2-digit ID if NX-4, NX-8, NX-12, NX-16
3-digit ID if NX16 (use leading zeros!! i.e.
user 7)
Prompts for a user number. Repeat 3
steps if another user code needs to be
programmed.
Code pad will beep 3 times if code is rejected.
Exits and saves data.
Prompts 'Please Enter Your Code'.
Prompts for a user number.
Prompts through the following list of attributes.
2-digit ID if NX-4, NX-8, NX-12, NX-16
3-digit ID if NX16 (use leading zeros!! (i.e.
for user 7)
Outputs used?
Open / Close Rprt?
Bypass enable?
Arm / Disarm?
NX-148E LCD Code Pad Installation and Setup Manual
Result
Result
If YES...
Output 4 enable?
Output 3 enable?
Output 2 enable?
Output 1 enable?
for
rd th
and 4