Table of Contents
Advertisement
5. If lag-bolts and anchors are to be used to secure the insert, the hole locations should be
marked with the unit in place. Remove the insert and locate the anchors.
6. Remove the faceplate panels from their box and assemble according to the following
instructions.
3.5. AIR CONTROL PLATE, FACEPLATE AND FAN ASSEMBLY
INSTRUCTIONS
1. Place the faceplate panels with the finished side down on a flat, soft, non-abrasive
surface.
2. Assemble the faceplate trim, attaching the mitered corners with the corner brackets.
(see Figure 3.5)
3. Line up the holes of the side and top panels and secure with the six (6) screws, washers
and nuts. (see Figure 3.6)
4. Slide the assembled trim over the edges of the faceplate.
5. Secure trim to faceplate using eight (8) "U" shaped clips. (see Figure 3.6)
Figure 3.5
6. Fan is already attached to the unit at the factory with two tie straps. Remove the two tie
straps and clip the blower assembly back onto the unit.
Figure 3.6
10
Advertisement
Chapters
Table of Contents
