Secondary Air Tube Replacement - Osburn 2000-I Owner's Manual

E.p.a. wood insert
Hide thumbs Also See for 2000-I:
Table of Contents

Advertisement

3.9. SECONDARY AIR TUBE REPLACEMENT

1.
Remove cotter pin at RH end of tube.
2.
Slide tube to left and lower tube end below RH plenum.
3.
Slide tube to right to remove.
4.
Reassemble in reverse order using a new cotter pin. The cotter pin is a hammerlock
style and locks into place by hitting the head sharply with a hammer.
5.
Note that any tube can be replaced without disturbing the baffle.
Important Notes:
The air tubes are identified for placement as follows:
Front to back:
Tube No. 1 41 Holes of .156" diameter
Tube No. 2 81 Holes of .109" diameter
Tube No. 3 81 Holes of .109" diameter
Figure 3.10
14

Advertisement

Table of Contents
loading

Table of Contents