Cordwood Fuel - Osburn 2000-I Owner's Manual

4.2. CORDWOOD FUEL

1. Fuel for the insert must not be stored closer than the required clearances to combustibles
and not in the space required for ash removal.
2. Your Osburn insert is designed to burn C
charcoal, or trash in the unit. Highly flammable items such as trash may ignite creosote in
the chimney, resulting in a chimney fire. Never burn salt wood, beachwood, chemically
treated wood, or wood removed from salt water, since the deposits left will deteriorate the
firebox. Damage caused by chemicals or salt is not covered under warranty.
3. Seasoned dense wood is recommended. Wood should be air dried in a covered
ventilated area for six months to a year or more. This reduces the moisture content of the
wood, resulting in better insert performance. Wood species with a moisture content of
20% or less are ideal. Dry seasoned wood can be distinguished from green wood by the
checks or cracks in the ends.
4. Wet or green wood will tend to cause the fire to smoulder, producing large amounts of
creosote. Creosote build-up could result in a chimney fire. This wood will also prove
difficult to keep burning properly, and fires will tend to go out. Green wood produces very
little heat, and sometimes causes customers to think that the insert does not work. If you
must burn wet wood, use only small amounts mixed with dry wood.
5. Decayed wood or low density wood has very little energy content or heating value, and will
not burn satisfactorily for long periods of time.
An example of the energy values of some common wood fuels is given in Table 4.1
For recommended wood sizes, refer to the specifications.
Common Heating Values of Cordwood
Hardwoods
Birch
White Oak
Alder
Million Btu/Cord
23.6
28.3
17.6
Table 4.1
18
F O
ORDWOOD UEL
Softwoods Million Btu/Cord
Douglas Fir
Hemlock
Jack Pine
. Do not burn coal,
NLY
20.6
17.1
18.4