Table of Contents
Advertisement
4.5
Dome Control
The DVR allows users to control a dome camera by the front panel.
In Live mode, users can press CHANNEL key to display the desired dome
camera in full screen. To enter Dome Control mode, press the DOME key and
press channel key 2 to display the hint screen. To exit the Dome Control
mode and return to live mode, press ESC or DOME.
To configure the dome control settings, see the following sections.
4.5.1
Dome Connection
Follow the steps to install dome cameras.
• See Setup Guide for RS-485 port pin definition.
• Connect the R+, R- terminals on the dome camera to the D+, D- terminals
on the RS-485 port by RS-485 cable respectively. Refer to the connection
figure illustrated in Setup Guide.
4.5.2
Dome Protocol Setup
The Dome Protocol item lists the available dome protocols for communicating
with dome cameras connected to the DVR. From the Main menu, select
<Camera Setup> and press ENTER. The following menu is displayed.
1. Analog Camera Select
2. Dome Protocol
3. Dome ID
4. Camera Title
5. Covert
6. Brightness
7. Contrast
8. Saturation
9. Hue
10. Audio Association
To configure dome protocol, select a camera first and set the communications
protocol associated with dome camera using the Direction keys and ENTER.
Analog Camera
NOTE: The settings become effective after saving the changes and
exiting from the menu.
DVR User's Manual
CH1
None
0
No
0
0
0
0
Yes
29
Advertisement
Table of Contents
