Electrolux T5130 Service Manual page 79

Troubleshooting
79
12:12 DRYING ERROR WITH AUTOSTOP PROGRAM
The error code is activated if the Auto Stop system does not register that the clothes are dry within
the maximum drying time. When the error is trigged the machine will automatically go to the cooling
module before the program ends.
The error code is reset from the timer by a short press on the control knob/start button. A long press
on the control knob/start button will make the timer reset and ongoing program will be ended.
If the clothes are still wet after maximum drying time and the dryer is not overloaded, check that the
heating system is working correct by using the ACTIVATE OUTPUTS menu when the machine is
in service mode.
Note!
Make sure that the fan is active before turning on the heat.
If the clothes are dry, check the outlet air sensor and harness, connectors and functions by reading
the electrical schematic and by using the SHOW INPUTS menu when the machine is in service mode.
12:13 DRYING ERROR WITH TIME PROGRAM
The error code is activated if a time program has continued longer than the maximum drying time
without the door has been opened.
When the error is trigged the machine will automatically go to the cooling module before the
program ends.
The error code is reset from the timer by a short press on the control knob/start button. A long press
on the control knob/start button will make the timer reset and ongoing program will be ended.
12:14 GAS ERROR PRESS GAS RESET BUTTON
The error code is activated if no flame has been detected by the gas control box. The gas control
box trig an input on the timer system, which generates the error code.
The metal probe of the flame sensor generates an electrical current when exposed to the burner's
flame. This signal is detected by the ignition control module which, in turn, cuts off the gas valve
immediately if the sensor does not indicate flame within 10 seconds. The gas control box does
3 attempts to ignite. The integrity of the sensor's electrical connection is, therefore, critical to
proper operation of this system. When the gas control box is in error mode a red LED is active on
the gas control box.
The timer sends a reset signal to the gas control box by a short press of the start button or service
button (depending on market and segment). When the gas control box receive a reset command
it removes the error. The timer will automatically restart the program when the error is removed
from the gas control box and when heat is allowed (vacuum needed) the gas control box will try
to ignite the gas again. A long press on the control knob/start button will make the timer reset
and ongoing program will be ended.
The gas error can also be reset at the gas control box. The machine will automatically restart
when the error is restored.
The error code can be trigged if:
• The gas control box fails to ignite. Check the gas supply and nozzle pressure.
If the gas control box do not have a gas error but the timer does, check the harness, connectors
and functions by reading the electrical schematic and by using the SHOW INPUTS menu when the
machine is in service mode.