NEFF C67P70N3GB Instruction Manual page 18

Always allow the appliance to cool down. Keep children at a
safe distance.
Removal
Open the oven door.
1.
Undo the two screws on the door using a TORX screwdriver
2.
(TORX 20). Hold the door panel firmly while doing this (Fig.
A).
Close the door slowly and pull out the panel upwards by the
3.
door handle. (Fig. B)
$
Hold the intermediate panel firmly and unscrew the retaining
4.
clips on the door. Slide the panel upwards and out. (Fig. C).
Do NOT unscrew the left and right-hand screws from the
5.
sheet metal part (Fig. D).
&
Note: Clean the glass panels with glass cleaner and a soft
cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, or sharp or abrasive
cleaning aids or detergents.
Refitting
Grip the upper section of the intermediate panel with both
1.
hands and insert it into the guide at the bottom. (Fig. A).
Caution!
Make sure that the panel is aligned evenly at the bottom.
The lettering must be positioned in the top right corner, so
2.
that it can be easily read. (Fig. B).
$
18
%
'
%
Tighten the retaining clips on the right and left of the panel
3.
using a TORX screwdriver (TORX 20). (Fig. C)
&
Insert the door panel into the guide with both hands. (Fig. D).
4.
Push the door panel downwards, lift it slightly and hook it in
5.
at the top (Fig. E).
'
Caution!
Make sure that the door panel is sitting flush with the control
panel.
Fully open the door, while holding the panels firmly with one
6.
hand (Fig. F).
Push the door downwards again and tighten the screws
7.
hand-tight using a TORX screwdriver (TORX 20) and close
the door. (Fig. G).
)
Caution!
The oven may only be used again when the panels are
correctly installed.
(
*