D-Link DVG-7022S User Manual page 28

DVG-7022S/7044S/7062 User's Manual
Trunk Hunting Order: To set FXO dial-out mode when there is an incoming call dialed FXO representative
number.
First Idle: The gateway will assign each unassigned call from first FXO line.
Sequential: The gateway will automatically assign the first unassigned call to the first FXO line. The second
FXO line will dial the second unassigned call out. Each line will be used.
Enable FXO/Trunk Extension Number: Select this function only when FXO receives 2 or more different
PBX or PSTN, or under special circumstances. Users are free to call out from a desired channel, if assigned.
If you register to a Proxy it MUST be checked.
Pick up Line by Dialing Extension Number: Allows user to dial just the FXO extension – 717 - to use
when the PSTN line is connected on the FXO port. If you are registered to a Proxy, it MUST be checked.
Wait for Caller ID before FXO / Trunk pick up: To detect caller ID from FXO port.
Transit in Busy Tone Limit: The duration gateway plays a busy tone before FXO hook-on. To notify the
caller from PSTN that this call is finished.
Detect FXO Line Presence: Enable this function to detect the line presence that FXO port is connected to
PBX or a PSTN line. Untick the check box to disable this function if it mis-detect line presence on FXO port
while ringing.
Ring (Early Media) Time Limit[10 - 600secs]：The timeout to cancel a call when no one answers.
Enable End of Digit Tone：The gateway will play a "Beep-Beep" tone to notify that the call is in progress.
D-Link Systems, Inc.
Telephony Settings
24