Removing Side Doors For Installation; Removing The Rear Motor Shield Sheet Metal; Placing Rear Shields Back On Unit - Harman Advance Pellet Stove Installation & Operating Manual

Side
Door
Fig. 9
Side Door
Magnets
Fig.10
Rear
Shield
Fig.11
Pallet Hold Down Bolts
Rear
Shield
Fig.13
Outside Air Knockout

removing Side doors for Installation

Rear
Shield
Rear Shield Retaining clip
Use hand hole to swing open side doors to at least
90 .
o
Remove side doors by lifting upward on the door until
the bottom pin is out of its hole. Move the bottom of
the door out and away from the pedestal base about
1/2". Allow the door to slide downward until the top
door pin is out of its top hole.
NOTE: Always remove the side doors and rear
shields to move the unit. This will keep them from
getting damaged.

removing the rear motor Shield Sheet metal.

NOTE: disconnect power to the unit before removing
the motor shields. danger of electrical shock. Hot and
moving parts could cause injury.
There are (2) #10 hex head screws holding each rear
shield. Using a 5/16" nut driver or socket, loosen the
(2) screws about 4 or 5 turns.
Slide the rear shields straight outward until the
ends come out of the rear retaining clips, as seen in
Fig.13.
There are two bolts holding the stove to the pallet
(see Fig. 11) Remove the bolts to move the stove.

Placing rear Shields back on unit

Fig.12
1. When replacing the shields, always insert the top
and bottom ends of the sheet metal into the retaining
clips first.
2. Slide the shields straight inward until the (2) hex head
screws are fully inserted into the stove slots.
3. Make sure the top edges of the shield are against
the hopper bottom and tighten screws .
The rear shields are split around the flue tail pipe
and outside air knockout. This allows removal and
installation of the rear shields with the unit completely
installed.
10
removing Side doors
Figure 9
Figure 10
Figure 11
Figure 12