Table of Contents
Advertisement
XXV Pellet Stove Owners Manual
PleaSe read thiS entire Manual beFOre inStallatiOn and uSe OF thiS Pellet Fuel-burning
rOOM heater. Failure tO FOllOw theSe inStructiOnS cOuld reSult in PrOPertY daMage, bOdilY
injurY, Or eVen death.
FOr uSe in the u.S. and canada. Suitable FOr inStallatiOn in MObile hOMeS
iF thiS harMan Pellet StOVe iS nOt PrOPerlY inStalled, a hOuSe Fire MaY reSult. FOr YOur SaFetY,
FOllOw inStallatiOn directiOnS.
cOntact lOcal building Or Fire OFFicialS abOut reStrictiOnS and inStallatiOn inSPectiOn
reQuireMentS in YOur area.
cOntact YOur lOcal authOritY (Such aS MuniciPal building dePartMent, Fire dePartMent, Fire
PreVentiOn bureau, etc.) tO deterMine the need FOr a PerMit.
cette guide d'utiliSatiOn eSt diSPOnible en FrancaiS. chez VOtre cOnceSSiOnnaire de harMan
hOMe heating.
installation & Operating Manual
SaFetY nOtice
SaVe theSe inStructiOnS
r15
# 3-90-00684
Advertisement
Table of Contents
Related Manuals for Harman XXV Pellet Stove
Summary of Contents for Harman XXV Pellet Stove
-
Page 1: Safety Notice
Or eVen death. FOr uSe in the u.S. and canada. Suitable FOr inStallatiOn in MObile hOMeS iF thiS harMan Pellet StOVe iS nOt PrOPerlY inStalled, a hOuSe Fire MaY reSult. FOr YOur SaFetY, FOllOw inStallatiOn directiOnS. cOntact lOcal building Or Fire OFFicialS abOut reStrictiOnS and inStallatiOn inSPectiOn reQuireMentS in YOur area. - Page 3 Damp as a result of using fuel with higher ash or mineral pellet fuel could turn back into sawdust which does not content. flow properly through the feed system. XXV Pellet Stove...
- Page 4 8”/20cm Back (B) 0” 0” Front (C)* 6”/15cm 18”/46cm *Measured from window opening. PROTECTION DU PLANCHER: CANADA (A)* 6” /15cm 8”/20cm 0” 0” (C)* 6”/15cm 18”/46cm Harman Home Heating- 352 Mountain House Road - Halifax, PA 17032 XXV Pellet Stove...
-
Page 5: Table Of Contents
Thank you for purchasing the Harman XXV Pellet Stove. The Harman XXV Pellet Stove is the culmination of elegance, convenience, functionality and dependability The XXV was thoughtfully designed to look captivating in every home. Intricately detailed oak leaves express the magnitude of craftsmanship that goes into making this stove a masterpiece. -
Page 6: Assembly & Installation
Viewing and aSh reMOVal dOOrS and installation and repair of this harman stove hOPPer lid tightlY clOSed during OPeratiOn. should be done by a qualified service person. we... -
Page 7: Installation
Structural integritY OF the ManuFactured hOMe FlOOr, wall, and ceiling/ rOOF MuSt be Maintained. warning dO nOt inStall in a SleePing rOOM. Fig. 5: Optional Top Vent Pipe Clearances XXV Pellet Stove... -
Page 8: Venting
48”. NOTE: Only the Harman Direct Vent Wall Pass-through K. The clearance to a mechanical air supply inlet must (part # 1-00-677077) or PL listed vent pipe wall pass- be a minimum of 10 feet. - Page 9 = Negative Static Pressure are easiest to see during start-up. Alternatively you can use a smoke pellet to leak test the venting before Fig. 6 lighting your first fire. inStall Vent at clearanceS SPeciFied bY the Vent ManuFacturer. XXV Pellet Stove...
- Page 10 Flex pipe part# can become the conduit for air supply, and reverse 1-00-08543 (25') under these conditions. Outside air: harman home heating and hearth & home Inlet Cover part# technologies strongly recommend attaching 1-10-08542 outside air in all installations, especially lower level Fig.
- Page 11 Note: Do not place joints within wall pass- throughs. cautiOn keep any materials that may be affected by the elevated exhaust temperatures at least 3 feet away from the flue termination Fig. 10 3 ft. to Combustibles XXV Pellet Stove...
- Page 12 * all jOintS FOr cOnnectOr PiPe MuSt be Secured with a MiniMuM OF three ScrewS. 6" from pipe to wall chiMneY MuSt be OF a tYPe Suitable FOr SOlid Fuel burning. Fig. 13 XXV Pellet Stove...
- Page 13 * all jOintS FOr cOnnectOr PiPe MuSt be Secured with a MiniMuM OF three ScrewS. chiMneY MuSt be OF a tYPe Suitable FOr SOlid Fuel burning. Fig. 15 XXV Pellet Stove...
- Page 14 * all jOintS FOr cOnnectOr PiPe MuSt be other combustible materials are Secured with a MiniMuM OF three ScrewS. allowed within 3" of the PL vent chiMneY MuSt be OF a tYPe Suitable FOr pipe. SOlid Fuel burning. 3" min. Fig. 17 XXV Pellet Stove...
- Page 15 & home technologies assumes no responsibility for, nor does the warranty extend to, smoke damage caused by reverse drafting of pellet appliances under shut-down or power failure conditions. XXV Pellet Stove...
-
Page 16: Esp Control
Stove Temp Mode, or OFF. Also allows you to vary the only. Requires special DDM room temperature in Room distribution blower speed by turning the knob to the high monitor supplied to Harman Temp Mode using the outer or low side of each mode. Dealers exclusively. -
Page 17: Low Draft Voltage Adjustment
If the unit is adjusted too low, the low low as possible. draft pressure switch will not allow the feed motor or the igniter to operate. XXV Pellet Stove... -
Page 18: Automatic Operation
The Manual position on the igniter toggle switch lets you light the stove manually, should the igniter fail for any reason. Secondly, if you are using the Harman battery back up system the Manual setting will prevent keeP hOPPer lid, lOading dOOr and aSh... - Page 19 If the stove is left to run out of fuel, you may get a 6 blink status light. If this happens simply reset the control board by turning the mode selector to OFF and back ON. XXV Pellet Stove...
- Page 20 The 1" ash bed uSe OnlY aPPrOVed FuelS. dO nOt burn is only a maximum burn rate and at most normal settings the ash garbage in StOVe. bed will be larger. XXV Pellet Stove...
-
Page 21: Manual Operation
Manual ignitiOn/OPeratiOn The XXV Pellet Stove is capable of manual operation. This also allows the operator to manually control operation during an emergency (i.e. igniter failure, or when using certain generators.) The unit can be switched between "AUTO" and "MANUAL" at any time during operation. - Page 22 The 1" ash bed HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY is only a maximum burn rate and at most normal settings the ash FROM THE HEATER WHILE IT IS IN USE. bed will be larger. XXV Pellet Stove...
-
Page 23: Room Sensor
The room sensor is essential for the XXV's excellent efficiency. nOte: it is recommended that the room sensor be installed, even if only installed on the rear of the unit as a return air sensor. XXV Pellet Stove... -
Page 24: Maintenance
5. Open the burn pot clean-out. Clean fly ash from the burn pot and replace the cover. See Figures 39 and 40 on page 26. Fig. 35 6. Remove the ash pan and dispose of ashes in an approved manner, according to local codes. XXV Pellet Stove... - Page 25 Contact your dealer to have the unit professionally inspected and cleaned prior to use. Fig. 38 XXV Pellet Stove...
- Page 26 (3 mm Burn pot igniter or more), it should be removed to reduce the risk of a chimney or venting system fire. Viewed from below through the ash pan opening. Fig. 41 XXV Pellet Stove...
- Page 27 Pellet Fines will build Fig. 43 up in this area Viewing glass The glass in your Harman stove is a special ceramic the channels and raised areas of the door itself. glass. Lay the glass retainers into position and install the •...
-
Page 28: Options
Vent wall Passthrough harman Part #1-00-677077 The Harman Direct Vent Wall Passthrough makes installing your Harman Pellet Stove with outside air a Outdoor Half lot easier. It is made to fit walls from 4 1/2" up to 10 1/8"... -
Page 29: Trouble Shooting
Fuel should not be stored within the stove installation 4. Hopper lid not closed properly. clearances or within the space required for charging and 5. Feed motor or combustion blower has failed. ash removal. See Page 7. XXV Pellet Stove... -
Page 30: Specifications
3 inch or optional 6" top exit Outside air Size 2 3/8" i.d. inch Fuse rating 6 amp wiring diagram HARMAN ACCENTRA & XXV PELLET STOVE WIRING DIAGRAM MALE/FEMALE CONNECTIONS BROWN WHITE GREEN WIRE IS GROUND REMOTE SENSOR PORTS 6 AMP GLASS FUSE... -
Page 31: Power Failure / Back-Up
Contact your dealer if you have questions about UPS compatibility with your appliance. harman Surefire 512h battery back-up The 512H connects to a 12 volt deep cycle battery that will run your appliance for up to eight (8) hours. It includes a trickle charge feature that keeps your battery charged when power is available. -
Page 32: Warranty
Hearth & Home Technologies Inc. LIMITED LIFETIME WARRANTY Hearth & Home Technologies Inc., on behalf of its hearth brands (”HHT”), extends the following warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer. WARRANTY COVERAGE: HHT warrants to the original owner of the HHT appliance at the site of installation, and to any transferee taking ownership of the appliance at the site of installation within two years following the date of original purchase, that the HHT appliance... - Page 33 WARRANTY CONDITIONS: • This warranty only covers HHT appliances that are purchased through an HHT authorized dealer or distributor. A list of HHT authorized dealers is available on the HHT branded websites. • This warranty is only valid while the HHT appliance remains at the site of original installation. •...
-
Page 34: Corn Burning Info
Addendum for Burning Corn and Pellet Fuel Mixture Harman pellet burning, free-standing stoves and inserts have been tested to ASTM E1509 for burning shelled corn in a mixture with wood pellets. The listing approves up to a 50% corn and 50% pellet mixture. Different mixtures of corn will have distinctively different burn characteristics depending upon moisture content and variety. -
Page 35: Service Parts List
XXV Pellet Stove Service Parts beginning Manufacturing date: n/a Pellet Stove ending Manufacturing date: active retired units: active 1-90-00677-5 (honey glo)(june 2009) 1-90-00677-2 (charcoal) (june 2011) 1-90-00677-10 (Mojave red) (jan 2010) 1-90-00677-1 (black), 1-90-00677-3 (goldenfi re) (june 2011) 1-90-00677-12 (Forest green)( jan 2010) - Page 36 XXV Pellet Stove Service Parts beginning Manufacturing date: n/a ending Manufacturing date: active IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement Stocked parts for your appliance please provide model number and serial number. All parts listed in this manual may be ordered from an authorized dealer.
- Page 37 XXV Pellet Stove Service Parts beginning Manufacturing date: n/a ending Manufacturing date: active IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement Stocked parts for your appliance please provide model number and serial number. All parts listed in this manual may be ordered from an authorized dealer.
- Page 38 XXV Pellet Stove Service Parts beginning Manufacturing date: n/a ending Manufacturing date: active IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement Stocked parts for your appliance please provide model number and serial number. All parts listed in this manual may be ordered from an authorized dealer.
- Page 39 XXV Pellet Stove Service Parts beginning Manufacturing date: n/a ending Manufacturing date: active #44 Feeder assembly Post Serial number 12871 44.15 44.12 44.16 44.14 44.13 44.1 44.2 44.11 44.10 44.3 38.9 44.4 44.5 44.8 44.7 44.6 IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement Stocked parts for your appliance please provide model number and serial number.
- Page 40 XXV Pellet Stove Service Parts beginning Manufacturing date: n/a ending Manufacturing date: active IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement Stocked parts for your appliance please provide model number and serial number. All parts listed in this manual may be ordered from an authorized dealer.
- Page 41 Service & Maintenance log Date Of Service Performed By Description Of Service XXV Pellet Stove...
- Page 42 Service & Maintenance log Date Of Service Performed By Description Of Service XXV Pellet Stove...
- Page 44 Proudly Printed On 100% Recycled Paper...