Table of Contents
Advertisement
WARNING!
ELECTRIC SHOCK CAN KILL
Turn the input power OFF at the mains switch & fuse box and remove mains plug from socket before
working on this equipment.
Have a qualified electrician install & service this equipment.
Allow machine to sit for 5 minutes minimum after disconnection from mains power to allow the power
capacitors to discharge before working inside this equipment.
Do not touch electrically live parts
1. Periodically (3-6 months depending on use / environment), remove the side/top panels of
machine and clean out machine with a low pressure dry air line paying particular attention to
PC Boards, Fan blades and switchgear
Failure to maintain plant can void manufacturers warranty.
2. Inspect input and output cables & hoses for fraying and cuts, replace if damaged present
3. Keep mig torch and earth cables in good condition
4. Clean air vents to ensure proper air flow and cooling
5. The fan motor has sealed bearings which requires no maintenance
Service & repair should only be performed by R-Tech welding trained personnel. Unauthorised repairs
performed on this equipment may result in danger or injury to the technician and machine operator
and will invalidate your warranty.
For your safety and to avoid electric shock, please observe all safety notes and precautions detailed
throughout this manual
The troubleshooting guide is provided to help you locate possible machine malfunctions
If fault / problem is not listed below check our Mig Welder Support page on our website
www.r-techwelding.co.uk/support.php
or contact R-Tech by phone. Contact details can be found on our website
16
Maintenance
Routine and periodic maintenance
Troubleshooting
16
Advertisement
Table of Contents
Need help?
Do you have a question about the I-MIG200 and is the answer not in the manual?
Questions and answers