Table of Contents
Advertisement
Troubleshooting
If your SWS2500NZ does not perfonn up to expectations, try the
suggestions listed below. If you cannot get satisfactory results, contact
your local retailer or Uniden (NZ) LTD for assistance.
20
Unit does not operate:
.
Check the power cord. Be sure the connectors
(Power LED not on)
are properly installed.
. Be sure ignition key is ON or in the accessory
position.
.
Fuse blown. Check and replace.
. Check power to lighter socket.
.
Vehicle electrical problem exists.
.
Make sure that the volume control is in the ON
position.
.
Clean cigarette lighter socket.
Unit fails the self test.
.
Return to your retailes.
Weak detection.
.
Check angle of unit.
.
Antenna/Sensor is obstructed. Relocate the unit
clear of any obstruction outside the windshield,
such as a wiper blade.
. Relocate the unit clear of the window tint.
Inaccurate or erratic
.
Loose power cord.
detection:
Check both connectors.
. Power cord is broken. Check and replace.
Beeps over bumps or
.
Check that the power cord is connected at both
rough road.
ends.
.
Clean cigarette lighter socket.
Beeps at same location.
.
Falsing because you have passed a motion
sensor or alarm.
Signal strength meter
.
For Highway use, be sure City Mode is OFF.
registers, but no audio.
.
Increase the volume.
The unit bounces against
.
Reposition so that the bumpers are firmly
the windshield.
against the windshield.
No X Band Detection
.
X Band delete mode has been selected. Power
light glows amber.
. Refer to page 16 for more details.
Beeps when vehicle
.
False alarm caused by another rader detector in
approches
closer proximity.
Advertisement
Table of Contents
