Table of Contents
Advertisement
(
Direct Connection
Warning: The SWS 2500NZ is designed to operate only with 12V DC,
negative ground power systems. Operation of the unit on
other voltages or polarities will cause damage to the unit
and may creme afire hazard.
The hard wire lead provided with the unit has bare wires at one end, and a
small connector at the other end.
1.
Connect the positive rod wire to a 12V DC source in your
vehicle's fuse box.
Connect the other wire to ground.
Run the cord from the fuse box to the SWS 2500NZ.
2.
3.
Fuse
I
0000
Box
0000
0000
DODO
Note: Ensure the cord does not inteifere with vehicle operation or
cause a iripping hazard.
4.
Plug the power cord connector into your radar detector at the jack
labeled "DC 12V".
12
Advertisement
Table of Contents
