Troubleshooting - Uniden LRD6699SWS Operating Manual

Uniden lrd 6699sws: operating guide
Table of Contents

Advertisement

If your LRD 6699SWS does not perform up to expectations, try the
suggestions listed below. If you cannot get satisfactory results, call the
Uniden Customer Service Center at (800) 297-1023, 8:00 a.m. to 5:00
p.m. Central Time, Monday through Friday.
Unit does not operate:
Unit fails the self test.
Weak detection.
Inaccurate or erratic
detection:
Beeps over bumps or
rough road.
Beeps at same location.
Signal strength meter
registers, but no audio.
The unit bounces against
the windshield.

Troubleshooting

Check the power cord. Be sure the connectors
are properly installed.
Be sure ignition key is ON or in the
accessory position.
Fuse out. Check and replace.
Check power to lighter socket.
Vehicle electrical problem exists.
Make sure that the volume control is in the
ON position.
Clean cigarette lighter socket.
Call Uniden Customer Service Center,
(800) 297-1023.
Check angle of unit. Point to the horizon.
Antenna/Sensor is obstructed. Relocate the unit
clear of any obstruction outside the windshield,
such as a wiper blade.
Relocate the unit clear of the window tint.
Loose power cord.
Check both connectors.
Power cord is broken. Check and replace.
Check that the power cord is connected at
both ends.
Clean cigarette lighter socket.
Falsing because you have passed a motion
sensor or alarm.
For highway use, make sure the Highway mode
is ON.
Increase the volume.
Reposition so that the bumpers are firmly
against the windshield.
20

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lrd 6699sws

Table of Contents