Table of Contents
Advertisement
Full Warning
\Vhen the SWS2500NZ detects a radar, laser, or safety warning signal, it
emits a distinct warning tone and the corresponding alert LEDs
(X, K, Ka, L, or SWS) will light and blink. The blink rate of the LEDs
increases and the signal strength meter LEDs light successively as the
signal source comes closer.
Audio Alert Only Operation
Press the AUDIO button for Audio Alert Only operation.
When the Audio Only is selected, the visual alert and signal strength
meter are disabled. In this mode, all lighted LEDs will dim. Press the
AUDIO button again for the Full Alert (audio and visual) Mode.
(Do not set the Volume control at minimum when in Audio Alert Only
because there will be no warning.)
Note: The audio alert tonesfor the 3 radar bands and laser are all
different.
15
Advertisement
Table of Contents
