Operation; Power On; Volume Control - Uniden SWS 2500NZ Operating Manual

Operation
You are now ready to enjoy the convenience and security of your
SWS2500NZ. Please read this section of the Operating Guide carefully
to familiarise yourself with the basic operation of this unit.
Power On
Turn the Volume control to switch on the power. When you power up
the SWS2500NZ, it performs a self-test of all its circuits. This test takes
about 5 seconds, during which you will hear five distinct alarm tones and
see all the LEDs. First, you will hear the X-band alarm for 2 seconds
while the X signal indicator, City, Audio, and Mute LEDs light. The test
also checks the meter LEDs. It is best to adjust the audible alarm during
this period. Then you will hear the K-band alarm, Ka-SuperWideband
alarm, Laser alarm and safety alert for I second each while the
corresponding signal indicator LED lights. (The P LED remains on until
you turn off the unit.)
After the SWS2500NZ confirms proper operation, the alert tones and all
LEDs, except the Power LED, turn off. If the Power LED does not light,
check the cigarette lighter socket connection. If the unit turns on and off
intermittently, or the alert tone sounds too often for no reason, check the
power cord connection at both ends to be sure it is not loose.
Volume Control
Adjust the Volume control
to a comfortable alarm tone
level for your vehicle. The
volume level does not have
any effect on the unit
sensitivity.
14