Download Print this page

Care And Maintenance; Troubleshooting; Specifications; Radar Detector Detectors - Uniden LRD450 User Manual

Long range radar/laser detector

Advertisement

– City mode delays all X band audio alerts until the
signal is at level 3.
– City I mode does not recognize X band
transmissions.
– Highway mode recognizes all bands and is
recommended for highway driving. (Default)
The following table provides an overview of key operations.
KEY
PRESS TO...
PRESS AND HOLD
TO...
MUTE
Turn alert audio off
Turn Auto Mute on (1
(1 beep) during alert
beeps) and off (2
audio. Mute
beeps) during standby.
cancelled 10 seconds
(A displays)
after alert ends.
DIM
Change brightness
Turn POP alert on (1
from:
beep) and off (2 beeps).
BRIGHT (3 beeps) to
P displays.
DIM (1 beeps)
to DARK (2 beeps).
CITY
Change mode from:
Turn K band filter on
HIGHWAY (3 beeps)
(LED dot turns on and 1
to CITY (1 beeps)
beep) and off (LED dot
to CITY I (2 beeps).
turns off and 2 beeps).
F displays briefly.
DIM +
NA
Return to factory
CITY
settings:
• Highway
• Bright
• Mute OFF
• K Filter ON
• POP OFF
• Auto Mute ON
MONITORING SPEED
A radar gun transmits radio waves at certain frequencies
that bounce off objects and return to the radar gun's
receivers. The radar gun then calculates the speed of the
object. The LRD450 recognizes the following bands/
frequencies used by radar guns:
BAND
FREQUENCY
X
10.525 GHz
K
24.150 GHz
Ka
33.400 - 36.000 GHz
Laser
800 nm - 1100 nm

RADAR DETECTOR DETECTORS

(RDDS)
Radar detectors are illegal in some states. Law enforcement
officers use special equipment to detect signals radiated by
radar detectors. If they are in a state where radar detectors
are illegal and the officer detects a vehicle using a radar
detector, the operator of that vehicle could lose the radar
detector and be fined.
The LRD450 is designed to be invisible to signals from the
Spectre l, Spectre lV, and VG-2 RDDs.

CARE AND MAINTENANCE

Use common sense and your LRD450 will provide trouble-
free service. Please keep the following tips in mind:
• Don't leave your unit on the dashboard during summer
months. Interior heat may exceed safe operating levels.
• Do not spray cleaners or other liquids on the unit.
Remove the unit when you are using these liquids.
• Do not use abrasive cleansers on the unit's exterior.

TROUBLESHOOTING

IF...
TRY THIS...
No display or audio.
Check the fuse in the plug.
Replace if necessary.
The unit alarms
Check the connections. Be sure
when the vehicle
they are all secure.
hits bumps.
The unit alarms
There may be a motion sensor or
briefly in the same
house alarm in use within range.
location but no radar
source was in view.
The detector did not
The officer may not have radar/
alert when a police
laser units turned on.
car was in view.

SPECIFICATIONS

Receiver Type:
Radar
Double Conversion Superheterodyne
Self-Contained Antenna
Laser
Pulsed Laser Signal Receiver
Frequency:
X
10.525 GHz
K
24.150 GHz
Ka
33.400 - 36.000 GHz
Laser
800 nm - 1100 nm
Detector Type:
Radar
Scanning Frequency Discriminator
Laser
Pulse Width Discriminator
Alarm Type
Beep (Detected Band and Signal
strength)
Antenna Type:
Radar
Linear Polarized E-vector Vertical
Laser
Convex Condenser Lens
Front
Laser
Concave Condenser Lens
Back
Dimensions
110.00 mm (D) x 69.00 mm (W) x 29.50
mm (H)
Weight
4.1 oz (115g)
Operating
-4° to +185° F (Radar/Laser)
Temp.
-20° to +85° C (Radar/Laser)
Storage
-22° to +203° F (Radar/Laser)
Temp.
-30° to +95° C (Radar/Laser)
Operating
DC 11.0 to 16.0 V
Power Soure
FCC/Industry Canada Information
FCC: AMW-LRD450
ICC: 513C-LRD450
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received, includ-
ing interference that may cause undesired operation.
Unauthorized changes or modifications to this equipment
may void compliance with the FCC Rules. Any change or
modification must be approved in writing by Uniden.
Changes or modifications not approved by Uniden could
void the user's authority to operate the equipment.
L'appareil est conforme aux normes d'Industrie Canada.
Son fonctionnement est soumis aux deux conditions suiv-
antes : (1) Ce dispositif ne doit pas causer d'interférences
et (2), il doit pouvoir accepter les interférences, incluant
celles pouvant nuire à son fonctionnement normal.
Tous les changements apportés à cet appareil, s'ils ne
sont pas expressément approuvés par Uniden ou toute
utilisation de celui-ci d'une autre manière que celle
décrite dans ce guide peut annuler votre autorisation de
le faire fonctionner.
One Year Limited Warranty
Keep your receipt! Proof of purchase is required for
warranty service.
WARRANTOR: UNIDEN AMERICA CORP.
("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants, for one year,
to the original retail owner, this Uniden Product to be
free from defects in materials and craftsmanship with
only the limitations or exclusions set out below.
WARRANTY DURATION: This warranty to the original user
shall terminate and be of no further effect 12 months
after the date of original retail sale. The warranty is inval-
id if the Product is (A) damaged or not maintained as rea-
sonable or necessary, (B) modified, altered, or used as
part of any conversion kits, subassemblies, or any config-
urations not sold by Uniden, (C) improperly installed, (D)
serviced or repaired by someone other than an autho-
rized Uniden service center for a defect or malfunction
covered by this warranty, (E) used in any conjunction with
equipment or parts or as part of any system not manu-
factured by Uniden, or (F) installed or programmed by
anyone other than as detailed by the Operating Guide for
this product.
STATEMENT OF REMEDY: In the event that the product
does not conform to this warranty at any time while this
war-ranty is in effect, warrantor will repair the defect and
return it to you without charge for parts, service, or any
other cost (except shipping and handling) incurred by
warrantor or its representatives in connection with the
performance of this warranty. THE LIMITED WARRANTY
SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY
PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND
EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE
WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING
BY OPERATION OF LAW, INCLUDING, BUT NOT LIMITED
TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY
DOES NOT COVER OR PROVIDE FOR THE
REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES. Some states do not allow
this exclusion or limitation of incidental or consequential
damages so the above limitation or exclusion may not
apply to you.
LEGAL REMEDIES: This warranty gives you specific legal
rights, and you may also have other rights which vary
from state to state. This warranty is void outside the
United States of America.
PROCEDURE FOR OBTAINING PERFORMANCE OF
WARRANTY: If, after following the instructions in this
Operating Guide, you are certain that the Product is
defective, pack the Product carefully (preferably in its
original packaging). Include evidence of original purchase
and a note describing the defect that has caused you to
return it. The Product should be shipped freight prepaid,
by traceable means, or delivered, to warrantor at:
Uniden America Corporation
C/O Saddle Creek
743 Henrietta Creek Rd., Suite 100
Roanoke, TX 76262
(800) 297-1023, 8 a.m. to 4:30 p.m., Central, Monday
through Friday
POP Mode is a trademark of MPH Industries, Inc.
Issue 1, November 2014

Advertisement

loading