Control Panel - ONEAC SE041XAT User Instruction Manual

UPS Operation

Control Panel

18
The front panel can be adjusted to be flush with the front of the UPS or set at an angle for easier viewing.
To move front panel between positions, press the panel on the lower edge. To restore panel to flush
position, reach behind panel and press center of support bracket while pressing panel down. Continue
pressing panel down until it latches into the flush mount position.
Select Esc Button
Menu Down Button
Bypass LED (yellow)
ON LED (green)
Fig. 14: Control Panel
Control Panel Messages and Audible Alarms
The comprehensive front panel display provides visual indication of unit status at any given time.
LCD screen indicates:
• Status
• Load
• Runtime
• Faults
• Menu Controls
To scroll through the menu controls on the LCD screen, press the "Menu up" or "Menu down" and
"Select" buttons. Each menu has a dedicated number. See Figure 15 for menu content.
Table 8. LED Codes
LED
• "ON" indicates UPS running online.
Lighted LEDs: • "BYPASS" indicates load fed from mains via automatic bypass.
• "BATT" indicates load fed from battery. An audible alarm signal is given.
• "BYPASS" flashing indicates that the bypass mains are out of tolerance.
Flashing LEDs:
LED Code
•Do not give command to switch off the UPS or to switch from "Online" to
"Bypass" in this status, as this would interrupt the operation of the
connected critical load.
ONEAC Sinergy SE II Series UPS User Manual
LCD Screen
Select Menu Button
Menu Up Button
Fault LED (red)
BATT LED (red)