Checking The Radio System - Pro Boat ShockWave 26 Owner's Manual

Brushless electric-powered deep-v
Hide thumbs Also See for ShockWave 26:
Table of Contents

Advertisement

The control arm should move toward the
back of the boat when right input is given.
Conversely, when left input is given, the
control arm should move toward the front of
the boat.
Right Turn

Checking the Radio System

Right Turn
The ESC will beep until you give full throttle
input. Do not hold full throttle for more
than a brief moment or damage to the drive
system and electronics may occur from
over-revving. Once the boat is in the water,
full throttle may be held indefinitely. The
auto sensing circuitry will select full throttle
position when you hold full throttle during
initial setup. Release the throttle trigger.
With the propeller free from any objects,
give some throttle input to ensure the motor
is working. If everything appears to be
functioning correctly, you are ready to run
your boat.
Note: The auto sensing voltage cutoff will
also cut off power to the motor when the
ESC senses the batteries are nearing full
discharge. To reset, return the throttle
trigger to neutral.
Note: If you are transporting your boat,
make sure you disconnect the battery from
the speed controller and then turn your
radio off until you are ready to run the boat.
Once ready, simply turn the radio on and
plug the battery into the speed controller,
again making sure the boat is in neutral.
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents