Lubricating The Drive Shaft - Pro Boat ShockWave 26 Owner's Manual

 2. Use a 1.5mm hex wrench to loosen the
setscrew connecting the propeller drive
shaft to the universal joint. Remove the
propeller shaft from the outdrive.
 3. Move the outdrive to a full left or right
turn and pull the drive shaft from the
stuffing box.

Lubricating the Drive Shaft

 4. Clean any debris and dirt from the flex
shaft with a degreasing cleaner. Lubricate
the drive shaft with thin oil. Reinstall the
drive shaft in reverse order. Be sure to
reinstall the nylon washer between the
universal and the stuffing box.
Note: Running the ShockWave 26 Brushless
EP RTR in salt water could cause some parts
to corrode. If you run the boat in salt water,
rinse it thoroughly in fresh water after each
use and lubricate the drive system.
Because of its corrosive effects, running RC
boats in salt water is at the discretion of
the modeler.
11