Integrated Peripherals - Advantech ARK-3380 User Manual

4.2.5 Integrated Peripherals

Note: These "Integrated Peripherals" options include configuration of
the board's chipset, with settings for IDE, ATA, SATA, USB, Super IO and
sensor devices. This page is chipset dependent.
• IDE Cable Detect [Enabled]
Some UDMA cables use a hole in the ribbon cable as a cable detect
mechanism to determine if a UDMA IDE or standard IDE cable is
installed. The default setting is: Enabled.
• DIO Group 1/2 Direction [Output / Input]
This item allows users to set the OnChip DIO status.
• OnChip IDE Device [Press Enter]
This item enables users to set the OnChip IDE device status; it includes
enabling IDE devices and setting PIO and DMA access mode, and in
some new chipsets also supports SATA devices (Serial-ATA).
• Onboard Device [Press Enter]
This item enables users to set the Onboard device status, including
enabling USB, AC97, MC97 and LAN devices.
- Onboard LAN Control (82551 Only) [Enabled]
Options are Enabled and Disabled. Select Disabled if the user does
not want to use onboard LAN controller1.
- USB Control [Enabled]
Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have USB peripherals. The choices: Enabled, Dis-
abled.
- USB 2.0 Control [Enabled]
Select Enabled if your system includes Universal Serial Bus (USB)
controller support USB 2.0 and you have USB peripherals. The
choices: Enabled, Disabled.
- USB Keyboard/Mouse Support [Enabled]
Select Enabled if the user plans to use a USB keyboard. The choices:
Enabled, Disabled.
• Super IO Device [Press Enter]
This item enables users to set the Super IO device status, including
enable Floppy, COM, LPT, IR and control GPIO and Power fail status.
ARK-3380 User Manual 40