Preparing To Charge - Motomaster 011-1504-0 Owner's Manual

1.11 To reduce the risk of a battery explosion, follow these instructions and those published by
the battery manufacturer and the manufacturer of any equipment you intend to use in the
vicinity of the battery. Review the cautionary markings on these products and on the engine.
1.12 This charger employs parts, such as switches and circuit breakers, that tend to produce
arcs and sparks. If used in a garage, place this charger 18" (46 cm) or more above floor
level.
2. PERSONAL PRECAUTIONS
RISK OF EXPLOSIVE GASES.
2.1 NEVER smoke or allow a spark or flame in the vicinity of a battery or engine.
2.2 Remove personal metal items such as rings, bracelets, necklaces and
watches when working with a lead-acid battery. A lead-acid battery can produce
a short-circuit current high enough to weld a ring or the like to metal, causing a
severe burn.
2.3 Be extra cautious, to reduce the risk of dropping a metal tool onto the battery. It might
spark or short-circuit the battery or other electrical part that may cause an explosion.
2.4 Use this charger for charging 12 V LEAD-ACID batteries only. It is not intended to supply
power to a low voltage electrical system other than in a motor-starting application. Do not
use this battery charger for charging dry-cell batteries that are commonly used with home
appliances. These batteries may burst and cause injury to persons and damage to property.
2.5
NEVER charge a frozen battery.
2.6 Consider having someone nearby to come to your aid when you work near a
lead-acid battery.
2.7 Have plenty of fresh water and soap nearby in case battery acid contacts your skin,
clothing or eyes.
2.8 Wear complete eye and body protection, including safety goggles and protective clothing.
Avoid touching your eyes while working near the battery.
2.9 If battery acid comes into contact with your skin or clothing, immediately wash the area
with soap and water. If acid enters your eye, immediately flood the eye with cold running
water for at least 10 minutes and seek medical attention right away.
2.10 If battery acid is accidentally swallowed, drink milk, the whites of eggs or water. DO NOT
induce vomiting. Seek medical attention immediately.
3.

PREPARING TO CHARGE

3.3 Clean the battery terminals before charging the battery. During cleaning, keep airborne
corrosion from coming into contact with your eyes, nose and mouth. Use baking soda and
water to neutralize the battery acid and help eliminate airborne corrosion. Do not touch
your eyes, nose or mouth.
3.4 Add distilled water to each cell until the battery acid reaches the level specified by the
battery manufacturer. Do not overfill. For a battery without removable cell caps, such as
valve regulated lead-acid batteries (VRLA), carefully follow the manufacturer's recharging
instructions.
3.5 Read, understand and follow all instructions for the charger, battery, vehicle and any
equipment used near the battery and charger. Study all of the battery manufacturer's
specific precautions regarding charging and recommended rates of charge.
3.6 Determine the voltage of the battery by referring to the vehicle owner's manual. If the
charger has an adjustable charge rate, charge the battery at the lowest rate first.
3.7 Make sure that the charger cable clips make tight connections.
RISK OF CONTACT WITH BATTERY ACID. BATTERY ACID IS
A HIGHLY CORROSIVE SULFURIC ACID.
3.1 If it is necessary to remove the battery from the vehicle to
charge it, always remove the grounded terminal first. Make sure
all of the accessories in the vehicle are off to prevent arcing.
3.2 Be sure the area around the battery is well ventilated while
the battery is being charged.
3
• •